Electronic Dog Fence, Remote Dog...

How it works: 1) Wall-mounted transmitter: Transmitter is the central controller to whole electronic system. Make sure the wire is set to a loop. 2) The receiver collar: Receiver (collar) will make a warning beep to begin with and then continuous stimulation if your dog attempts to approach wire boundary. 3) How to install the system: *Design your containment area and calculate the amount of wire needed. *Install the wall transmitter. *Lay out the perimeter wire. *Connect the perimeter wire to the wall transmitter. *Verify transmitter is functioning without problem. *Set up the receiver and then, test the containment system and adjust the field width. *Install the boundary wire and training flags. *Fit collars to your dogs and train your dogs Package Includes: 1 x indoor wall-mounted transmitter 1 x power plug 1/2/3 x adjustable receiver collar 1 x 300 Meter Roll of fence Wire 4 x Screws 1 x User’s manual 2 x Extra metal contact points

1. Coverage Area Is 100% Customizable Up to 1.2 Acres 5,000 Sq. Ft. Simply Bury the Wire (Up To 1000 Feet Long) Around the Designated Area At the side of the Included Perimeter Flags to Begin Training Your Dog.
2. Pet Collar Fits Dogs 8 Pounds and Up with Neck Sizes from 8 to 20 Inches (Small/Medium/Large/Extra Large Dogs). Every collar will vary quite in sensitivity and the difference in range could be 6-12 inches but it’s going to not impact how the system works. Perform the “Short Loop Test” to decide if the transmitter must be replaced or if the boundary wire is broken.
3. A couple of Collar System Where 1 Transmitter Can Pair Up With Infinite Number of Receiver Collars.
4, built-in speed detector – the faster the dog moves, the higher the
5. Collar Receiver is Water Resistant and Rain proof. Receiver Delivers Protected Static Correction Shock Stimulation When Pet Strays Into Warning Zone.